Specifications:
- Size: 20*20 M3 holes with vibration damping
- MCU: STM32F722RET6 216MHz
- Gyro: MPU6000 6-Axis
- Input: Up to 12S (50V) direct battery power Yes! 12S!
- USB type C
- DJI direct plug (6 pin)
- VTX pit mode switch - configured in Betaflight modes
- 5V or VBAT selectable for VTX and CAM power
- One wire Analogue Camera Control
- 4 Led pads (one at each corner) for easy LED installation - up to 40 LEDs on white and 100 LEDs in colour - perfect for FAI international races - shares 5V with 5V/2A BEC
- 6 UARTS, 4 full UARTS with RX AND TX pins
- 8 pin 4 in 1 ESC plug
- M5, M6 pads for additional motor outputs
- Buzzer pads for external buzzer
- Built in Betaflight OSD
- Boot button
- Logical pin layout for cleanest build
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
VTX pit switch can't control the DJI plug
Package Included:
- 1x Wizz F7 HD 20x20 Flight Controller
- 6x M3 vibration damping
- 1x SH1.0 8PIN Cable (60mm) one side open ended
- 1x DJI Air Unit Cable (40mm)